qertsample.blogg.se - Radiant defense operation triola

Then set the machine to the servo mode.

Set the power to the highest level for the quick heating of the baby tray, bed sheets, and other kinds of clothes used in it.

Connect the power cable to the plug and then turn on the machine.

This is because, if the sensor gets damaged the machine will give you an error in servo mode.įollow the following steps to operate the baby warmer.

If the temperature sensor damages, then you may need to use the manual mode until the new sensor is available.

So, in this case, you need to set the machine to the manual mode at the lowest possible value.

If the baby is suffering from fever, setting the machine to the servo mode will give out a buzzer periodically.

In such a case, you need to set the manual mode to the highest setting.

If the baby is facing a hypothermic condition, the temperature will fall quickly.

Once the baby is placed on the tray, set the machine to servo mode. Thus, the tray will quickly gain temperature. So, set the manual mode to the maximum value.

If you are planning to bring a baby under the care of a radiant warmer, it is better to use the manual mode.

There are few conditions when it is better to use the manual mode rather than the servo mode.

The other benefit is that even when the temperature sensor fails to operate, the machine can operate in this mode. Due to this reason, the tray where the baby is to be placed will warm up quickly before putting the baby. So, the machine will continuously deliver maximum heat energy. The main benefit of this mode is that you can set the energy required at 100%. For example, 20%, 40%, 60%, 80%, and 100% of the total energy may be delivered by the machine.

Here, the user manually sets the temperature intensity. In this mode, the machine does not consider the set and the present value. So, it will take a longer time to stabilize. But, the main drawback of this system is that, once the present value goes closer to the set value, the heating rod will begin to deliver less energy. This mode is mainly used during the treatment because it helps to maintain the required temperature. In this way, the machine helps to maintain the set value. On reaching or crossing the set value, the heating element will be completely turned off. When the present value goes nearer to the set value, the intensity of the heat delivered will decrease. On applying the heat to the baby, the present value will increase. If the present value is lower than the set value, the machine will supply the heat to the baby. In this mode, the mainboard compares the temperature difference between the set and the present value. Servo mode is also known as the automatic mode. They are the servo mode and the manual mode. The baby warmer provides you with two types of modes. X-ray Plate:- The plate may be available at the lower side of the baby tray.Drawer:- You can use the drawer, usually found at the bottom of the machine, for storing medical tools and drugs for treating the baby.Also, the machine might have the feature for the up and down movement of the baby tray. The trolley allows moving the machine from one place to another. Trolley:- The entire set of the light, heater, and tray is placed on top of the trolley.However, an air probe may not be available in most of the models. The other probe can be used as the air probe for measuring the temperature of the atmosphere. One of the probes can be used as the skin probe for measuring the temperature of the skin. Temperature Sensors:- You may have one or two sets of temperature probes to measure the temperature.The tray lies directly below the heating rod. Baby Tray:- This tray is the place where the baby is placed.Display Board:- The display board shows the set temperature value, present value, and the errors that may occur during its long run.Main Board:- This board is useful for controlling the entire machine.Observation Light:- This light is necessary to observe the baby during nighttime.Heating Rod:- This is the source of heat radiation.Some of the basic external parts of the radiant warmer are stated below. Advantages and disadvantages of radiant warmer.